When we fish the holes or rocks that can be hooked rod or nailed, we need this hook to get the rod out and recover., so we have two things in one, to save the rod and gaff or hook
To make this manualidadsub, we need an old rod, a plate and a colleague that we have the weld or solder:D
1 old steel rod of size greater than 130 ctms.
1 steel plate thickness of 4 mm x 4 long x 3 ctms ctms wide.
1 friend who has a shop and let us use the tools or possibly get things ready and we leave the weld or weld us:D
Just follow the steps, cut the rod by the first notch and then through the hole of death or flap
We end on the one hand, with a spiral around the hook do if you have heat or flame better, let cool
not put directly in water but lose the stainless steel hardness.
For Tenos plate to make the notch with a thin disc for stainless steel and a little vee top to fit the notch in the ass rod
perched as we have the cut, will guide us to the notch, are all the same thickness does not vary from one rod to another.
Reserve a piece of hand width for jalahera or tails, on the other ends of the weld.
If you see the pictures and you follow the steps are easy, like you is just stick is even better to have two old, so the piece of the cross cut off the other rod.
<º))))><
Cuando pescamos al agujero o rocas que la varilla se pueda quedar enganchada o clavada, necesitamos este gancho para lograr sacar la varilla y recuperarla, asi tenemos dos cosas en una, para salvar la varilla y bichero o gancho
Para hacer esta manualidadsub, necesitamos una varilla vieja, una pletina y un colega que nos la suelde o tenga soldador
1 varilla vieja inox de tamaño mayor a 130 ctms.
1 pletina inox de 4 mm de grueso x 4 ctms de largo x 3 ctms de ancho.
1 amigo que tenga un taller y nos deje usar las herramientas o en su caso llevar las cosas preparadas y nos las suelde o nos deje soldarlas
Solo hay que seguir los pasos, cortamos la varilla por la primera muesca y después por el agujerito de la muerte o aletilla
hacemos punta por una parte, con un caracol hacemos la vuelta del gancho si tenéis calor o soplete mejor, dejamos enfriar
no meter directamente en agua sino perdemos el acerado inox, la dureza.
Para la pletina tenos que hacer la muesca con un disco fino para inox y en cima un poco de uve para encajar la muesca en el culo de la varilla
enrocada como tenemos la parte cortada, nos servirá de guía para hacer la muesca, son todas del mismo grueso no varían de una varilla a otra.
Reservamos un trozo del ancho de mano para la jalahera o cruz, en el otro extremos la soldamos.
Si veis las fotos y seguís los pasos es fácil, como la varilla os viene justa es mejor tener dos aunque sea vieja, asi el trozo de la cruz la cortaremos de la otra varilla .