overhang for spring steel 32cm and 7mm spear should be same for Stainless 17-4 ph ?or I have to reduce the SS spear by 10 cm?
Posts by mosaad
-
-
I need to balance my gun and choose the accurate set up ,bad experience with salvimar 160 cm shaft SS it whip very easily ,I am afraid to order more SS and all my wood gun will be ruin ,pathos available in cheap price .
-
I have used the 1/4 bent spear from my stock as a axial of roller ,everything finish but didn't success to take any good picture for my works ,I try later ,my wife said you need expensive camera and i am out of $
-
I have read few posts and there is a 3 type of shaft
- the one i use from RA is quench spring steel
- second cressi stainless steel but don't know if harden or not its cobber color
- third the stainless from pathos and teak sea which is white color
- their is a hardened alloy 17-4 ph stainless also
anyone can help to distinguish between these ,I want to have a spear won't rusted like RA and also have same hardness and density to not overpowered .
-
I apologize for the wrong calculation ,half of wall thickness have been used
-
316 SS and thickness till 15 mm they can cut
-
Polyurethane sealant on handles
-
2 coat epoxy and final coat is spar varnish from ACE hardware ,I ll post pictures later
-
I take the epoxy to small pot ,much easier to take by syringe the required quantity without need to open the large can
-
bending simple bench ,glue the resting pad ,drill saw bit for making slot opening
-
I want to know how to fix your wood handle when 75% of the trigger body is located where you glue your customized handle ,after you open your track and trigger pocket usually you install your regular trigger and then rotate and drill a pocket for the handle ,glue it and finish ,but if you try the same for the reverse you will have both side open ,I was planning to buy some and try but if someone can share his experience .
-
I just do CAD/CAM design then take the flash drive to CNC laser cut shop ,cut 2mm 316 ,do small TIG welds and its ready ,extra pieces for friends or future projects ,if someone can share a plan of wood handle it will be great
-
ss works
-
few steps more
-
for band alignment in roller which one is prefer in the picture ? band bottom aligned with shaft bottom or center line of band and center of shaft is same?
-
the different in high tide and low tide usually more than 1.5m ,very high speed current it can take you miles from your diving place , if u don't use something to hold you find your self in the next city
-
I have change some in my old anchor and like to share it weight less than 500 grams made from marine A4 very effective during big peak current
-
I have used graphite flakes and not powder because it wasn't available ,the results was unsatisfactory and flakes can't used for that ,before drilling the holes I made one sample and didn't waste time for repairing wrong holes ,trigger is neptonic euro ,pin hole located 1/8 from side and 1.5 from the front housing ,deep track router bit as in picture
I ll ask my wife to take pictures as I can see I don't have any skill for that -
updated
-
slow down the temperature here is 45 Celsius ,humidity 80% summer already start