Orca shafts

I believe there is a distributor in Florida, he was on the other board. Let me know if you need help finding him.

Marco, wait a little bit. I will have coated shafts shortly. What length and diameter do you need?

Dan I will be interested in a 130 cm x 7.5 mm shaft and a few 160 cm tabs if they have shark fins.

Quote from Dan

Marco, wait a little bit. I will have coated shafts shortly. What length and diameter do you need?

Finally!!!

I would like a 190cm euro with a rest tab, don't care if is stainless or coated 7 or 8mm but it must have a rest tab or pin or I will cut down my 150 to a smaller size. Finding shafts for it is a pain. Any suggestions?

I'll have a 190cm 7.5mm soon, but you'll need to add the rest pin yourself.

Ok!

Dan,

Great to year you will be getting the shafts soon, will they be tri-cut?

Yes tri-cut, 3 notches. Wasn't there a disease that you can catch from rusty nails? I guess saltwater disinfects everything <img src= " height="23" srcset="https://spearfishing.world/forum/images/smilies/emojione/1f606@2x.png 2x">

I think you can get lock jaw but that might be a side effect. Tetnis shots every 7 years!

Quote from Dan

Marco, wait a little bit. I will have coated shafts shortly. What length and diameter do you need?

Fine Let us know when and $$

Are you going to continue carrying the stainless ones too?

I have my tetnis shot and my shafts have no rust at all <img src= " height="23" srcset="https://spearfishing.world/forum/images/smilies/emojione/1f606@2x.png 2x">

Yes I'll continue to have both stainless and coated. BTW I have a full range of sizes in American shafts with shark fin tabs, like Riffe.

Quote from Marco

Psycho, I have a 130 CF Aimrite Venom I could trade. Which 150 is yours?

Dan: I use 7 mm x 170 cm, my friends use 7.5 mm x 180 cm. Notched for me, pinned for them.

I'm looking to pay less than 40$ for the shafts. I found them in the past but Jim Doe went out of business.

Marco, it's a pelaj kanji in real good condition. Si te interesa hablamos ya que no lo uso casi nada.

Is Jim doing ok? Have not heard from him in a while.

Quote from Marco

Psycho, I have a 130 CF Aimrite Venom I could trade. Which 150 is yours?

Dan: I use 7 mm x 170 cm, my friends use 7.5 mm x 180 cm. Notched for me, pinned for them.

I'm looking to pay less than 40$ for the shafts. I found them in the past but Jim Doe went out of business.

orca are the same shafts as pelaj.